Skip to main content

Modeling the Microstructure Evolution During and After Hot Working in Martensitic Steel

Time: Fri 2021-01-22 10.00

Location: Stockholm (English)

Subject area: Materials Science and Engineering

Doctoral student: Nima Safara Nosar , Strukturer, Dalarna University

Opponent: Professor Hans-Olof Andrén, Chalmers University of Technology

Supervisor: Professor John Ågren, Materialvetenskap; Professor Engbeg Göran, Dalarna University

Export to calendar

Abstract

In this study, the goal is to predict the microstructure evolution during and after the hot working of a martensitic stainless steel with 13% chromium using a physically-based model in the form of a MATLAB toolbox. This model is based on dislocation density theory and consists of coupled sets of evolution equations for dislocation, vacancies, recovery, recrystallization, and grain growth.

The focus in this work is on the flow stress calculation and the effect of second phase particles on the strengthening mechanisms in the material at elevated temperatures. Recovery and recrystallization are also studied for this alloy during deformation and following stress relaxation.

The experimental part of this work was performed with a Gleeble thermo-mechanical simulator over the temperature range of 850 to 1200°C. Samples were investigated later by a light optical microscope (LOM) and a scanning electron microscope (SEM) equipped with energy dispersive X-ray spectroscope (EDS). Hardness test and phase isolation were also performed on the samples and the results are compared with the modeling results.

The model can satisfactorily predict the grain growth, recovery, recrystallization, and flow stress for this alloy. Further investigation on the second phase particles showed that the measured mean size of carbides has a good agreement with what is obtained from the model and the hardness values. On the other hand, the modeled volume fraction of the carbides followed a slightly different trend comparing to hardness values, and phase isolation results at temperatures higher than 1000°C. Additionally, the Ms temperature and fraction of the martensite phase are calculated for quenched samples where the results are following the measured hardness values.

Finally, the Zener-Hollomon parameter (Z) and its relation to the flow stress and the activation energy for deformation are defined. The dynamic recrystallization (DRX) kinetic is modeled and the fraction DRX was calculated at various temperatures and strain rates for this alloy.

urn.kb.se/resolve?urn=urn:nbn:se:kth:diva-287278